Recipcuioting; Attach Mounting Plate To Wall - GE PSA1200 Installation Instructions Manual

Installation Instructions
C
RECIRCULATING (Non-vented Ductless)
INSTALLATION OVERVIEW
C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. Adjust Blower
C4. Mount the Oven
C5. Install Charcoal Filter (not supplied)
Ci
ATTACH THE MOUNTING PLATE
TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to %" onto each bolt.
To use toggle bolts:
Spacing for Toggles
More Than Wall
+|++/<— Thickness
I
. i Toggle Wings
Mounting
wf!
Toggle
Plate = ,/ Bolt
af
Bolt End
Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the
wall and that the plate is properly centered under the
cabinet.
ACAUTION: Be careful to avoid pinching
fingers between the back of the mounting plate and
the wall.
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
19
C2
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP CABINET
You need to crill holes for the top support screws and
a hole large enough for the power cord to fit through.
Ss
e Read the instructions on the TOP CABINET
TEMPLATE.
* Tape it underneath the top cabinet.
¢ Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
ACAUTI O N: Wear safety goggles when
drilling holes in the cabinet bottom.