Table of Contents
Advertisement
1. Opposite blade edge (in position for measuring)
2. Level surface
3. Second measured distance between blade and surface (B)
A.
If the difference between A and B is greater
than 3 mm (1/8 inch), replace the blade with
a new blade; refer to
(page 43)
and
43).
Note:
If a bent blade is replaced with a
new blade, and the dimension obtained
continues to exceed 3 mm (1/8 inch), the
blade spindle could be bent. Contact an
Authorized Service Dealer for service.
B.
If the variance is within constraints, move to
the next blade.
6.
Repeat this procedure on each blade.
Removing the Blades
The blades must be replaced if a solid object is hit, if
the blade is out of balance, or if the blade is bent. For
best performance and continued safety conformance
of the machine, use genuine Toro replacement blades.
Replacement blades made by other manufacturers
may result in non-conformance with safety standards.
1.
Hold the blade end using a rag or thickly-padded
glove.
2.
Remove the blade stiffener (32-inch decks only),
blade bolt, the curved washer, and the blade
from the spindle shaft
Figure 60
Removing the Blades
Sharpening the Blades (page
(Figure 61
and
Figure
g014973
1. Sail area of the blade
2. Blade
3. Curved washer
1. Sail area of the blade
2. Blade
Sharpening the Blades
1.
Use a file to sharpen the cutting edge at both
ends of the blade
Note:
Maintain the original angle.
Note:
The blade retains its balance if the same
amount of material is removed from both cutting
62).
edges.
1. Sharpen at original angle.
43
Figure 61
81 cm (32-Inch) Decks
4. Blade bolt
5. Blade stiffener
Figure 62
107 cm (42-Inch) Decks
3. Curved washer
4. Blade bolt
(Figure
63).
Figure 63
g000551
g027833
g000552
Advertisement
Table of Contents
