Table of Contents
Advertisement
Setup
4. Do not dispose of the battery cells into household garbage. Properly recycle
the used battery cells.
5. Do not charge the battery cells with other electrical devices.
Check Battery Indicator
If you receive a check battery warning, it indicates
one of the following:
1. There are no battery cells in your Handset. You'll
need to install battery cells into your Handset.
(See the Installation of Battery Cells section on
the previous page.)
2. You have accidentally installed alkaline batteries
into the Handset. (Alkaline batteries must NEVER be used in this phone. See
the warning on the previous page for additional information about batteries
for this telephone.)
3. The rechargeable batteries in your Handset need to be replaced by new batteries.
4. The batteries have been installed incorrectly. Please reinstall. (See Installation of
Battery Cells.)
Connecting to Phone Line
Plug one end of the telephone line cord into the jack at the bottom of the Base
Unit. Then plug the other end of the cord into the wall jack.
Checking for Dial Tone
After the battery cells are charged, pick up the Handset and press ON. PHONE
will appear on the Handset display, and you will hear a dial tone. If not, see In
Case of Difficulty.
Tone/Pulse Selection
Your phone is preset for tone dialing. See Handset Settings for details.
CAUTION: Use only the VTech power supply provided with your telephone.
IMPORTANT:
FOR MAXIMUM PERFORMANCE OF
YOUR CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your
Base Unit.
2. Install your Base Unit and Extension
Handsets away from electronic equip-
ment, such as personal computers,
television sets and microwave ovens.
3. In locations where there are multiple
cordless telephones, separate Base
Units as far away as possible.
4. Install your telephone equipment away
from heat sources and sunlight.
5. Avoid excessive moisture, dust or
extreme cold.
8
Advertisement
Table of Contents
