Table of Contents
Advertisement
Setup
Installation of Battery Pack in Handset
Connecting Power to Base Unit
Choose a location for the Base
near an electrical outlet and a
telephone jack.
This phone requires a modular
telephone jack and a standard
electrical outlet (110v AC) not
controlled by a wall switch. Plug
the AC power adaptor into the
electrical outlet and the DC
connector to the jack on the
bottom of the Base Unit.
Charge the Battery Pack
The Handset should be charged initially for 12 hours. Afterwards, a maintenance charge
of at least 10 hours is sufficient. Maximum talk time on a full charge is approximately 5
hours. Maximum standby time is 5 days. Look for the charging bull animation on the
Handset as it charges.
Follow the steps below:
1.
Remove battery compartment
cover by pressing on the
indentation and sliding
downward.
2.
Align the two holes in the plug
with the socket pins, then
snap the plug into place.
3.
Place the battery pack in the
compartment, with the wires
in the lower left corner, along
the bottom of the pack. Angle
the top half of the pack in first,
under the 2 claws. Then snap
the lower portion of the pack
into place. Place the wires
uder the guide, located below
the battery pack.
4.
Replace cover by sliding it up
into place.
4
Advertisement
Table of Contents
