Evenflo Exersaucer Sweet Tea - Bouncing Activity Saucer Manual

Evenflo Exersaucer Sweet Tea - Bouncing Activity Saucer Manual

Advertisement

Evenflo Exersaucer Sweet Tea - Bouncing Activity Saucer Manual

Unpacking


Toy kit contents vary by model.

Assembling the ExerSaucer

Stage 1 (Optional)

Mat and toys vary by model.
Stage 1 is used for infants from birth to 4 months old.

  1. Place optional mat on floor. Place feet on either side of mat, as shown. lnstall toy bar into feet, as shown. Press toy bar down firmly until it snaps into place.
    Assembling - Stage 1 - Step 1
    Pull up on the toy bar and toys installed into the feet to make sure they are locked in place.

Stage 2

Stage 2 is used for infants 4 months old (who can hold up head and neck unassisted) to walking age and under 30 inches tall.

  1. Turn ExerSaucer base upside down and locate three (3) stabilizer feet . Insert one side of foot into the foot bracket hole and twist the foot until the other side snaps into the opposite hole . Repeat until all three (3) stabilizer feet are installed.
    Assembling - Stage 2 - Step 1
    To use stabilizer feet:
    Flip the three (3) stabilizer feet out from beneath base to prevent ExerSaucer from rocking.
  2. Place seat ring upside down and locate the wheel holders . Snap six (6) seat wheels into wheel holders, as shown.
    Assembling - Stage 2 - Step 2
  3. Turn seat ring right side up.
    Align triangle on the back of the seat ring with the triangle on the seat pad label.
    Snap the plastic tabs on the pad over the pegs on the seat ring.
    Continue this process until all tabs are attached to all pegs, then push the seat pad down inside the seat ring.
    Assembling - Stage 2 - Step 3
  4. Press assembled seat ring down firmly onto the top of the tray until it snaps into place and spins freely.
    Assembling - Stage 2 - Step 4
  5. Locate three lower legs and the base . Align the tabs on the lower legs with the slots in the base, then snap the lower legs onto the base. Repeat for all three lower legs.
    Assembling - Stage 2 - Step 5
    Note: Make sure the tabs on the lower legs have locked completely into the base, as shown, by moving the legs from side-to-side. If they are not completely locked in place, repeat this step until they are locked securely.
  6. Locate the tray and three spring domes .
    Place each spring dome onto the tray over each leg opening, as shown. Press the spring dome downward while turning until it locks into place.

    If you don't line up the alignment guides properly, the spring dome may come off of the tray and cause injury.
    Make sure the alignment guides line up properly, as shown.
    Assembling - Stage 2 - Step 6
  7. Turn the tray over and place three large springs the center of each spring dome .
    Assembling - Stage 2 - Step 7
  8. Insert three upper legs over the springs and onto the tray. Twist each upper leg, as shown. Make sure height adjustment button is facing outward.
    After all three upper legs are installed, turn tray over to the upright position.
    Assembling - Stage 2 - Step 8
  9. Align and start each upper leg into the lower leg . Push button and guide upper leg into lower leg until upper leg snaps into place.
    Assembling - Stage 2 - Step 9
    To adjust height:
    ALWAYS remove baby from ExerSaucer before adjusting. Push button until the desired position is obtained. Make sure that all three legs are adjusted to the same position.

    During use, allow the baby's toes only to touch the base. DO NOT allow the baby to stand flat-footed on the base. As baby grows and becomes more active, raise the tray to the next level so that baby enjoys the most comfortable fit and maximum use of the rock, spin, and bounce features.

Attaching the Toys

Attaching the Toys

  • Install batteries.
  • Push power switch to "ON".
  • Pull on electronic toys to activate.*

* Not every toy is electronic.

Care and Maintenance

Machine wash pad in cold water, delicate cycle. Tumble dry, low heat for 10 to 15 minutes. DO NOT use harsh detergents or bleach. DO NOT dry clean. Wipe plastic parts with mild soap and water.

Battery Information

Battery life varies with use.
Safety Information: Batteries are small objects. Batteries must be replaced by adults. Follow the polarity (+/-) diagram in the battery compartment.

  • DO NOT mix old and new batteries.
  • DO NOT mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
  • Remove batteries before storing unit for a prolonged period of time.
  • DO NOT allow unit to get wet.
  • Promptly remove dead batteries from the toy.
  • Dispose of used batteries properly.
  • Only batteries of the same or equivalent type, as recommended, are to be used.
  • DO NOT dispose of batteries in fire, as batteries may explode or leak.
  • DO NOT use rechargeable batteries.
  • DO NOT recharge non-rechargeable batteries.

Troubleshooting

Toy does not turn on or does not respond

  • Make sure batteries are installed correctly.
  • Make sure battery cover is correctly secured.
  • Install new batteries.

Toy makes improper responses

  • Check or install new batteries.


TO AVOID INJURY, FOLLOW THESE INSTRUCTIONS IN THE ORDER PRESENTED!

  • Do not allow other children to play near the product when it is occupied.
  • Read all instructions before assembly and use of product. Keep instructions for future use. Adult assembly required.
  • Inspect the product before each use. DO NOT use this product if it is damaged, broken, or missing parts. Take care when unpacking and assembling; contains small parts and some items with sharp edges.
  • To prevent possible choking hazard, remove and immediately discard packaging material before using this product.
  • NEVER leave child unattended. ALWAYS keep child in view while in product.
  • For use by children at least four months old who can hold up their head and neck unassisted.
  • FALL HAZARD! DO NOT use with children who can walk.
  • DO NOT use until baby can sit up by him or herself.
  • Stop using this product when your child reaches any of the following developmental stages:
    • Is walking;
    • Is over 30" (76 cm) tall;
    • Can climb out of the product;
    • Can stand flat-footed in the unit when adjusted to its highest level. Allow only the baby's toes to touch the base.
  • Keep children away from unassembled product.
  • DO NOT adjust height while baby is sitting in ExerSaucer.
  • DO NOT allow child to sleep in ExerSaucer.
  • DO NOT spin baby in seat. Only permit baby to rotate the seat.
  • NEVER use near stairs. NEVER use near ranges, radiators, space heaters, fireplaces.
  • NEVER use as a sled.
  • The ExerSaucer should not be left outdoors in direct sunlight, or any place where temperatures are likely to exceed 100˚F (38˚C).
  • DO NOT allow unit to get wet. DO NOT fill ExerSaucer with water. NEVER use as a flotation device.
  • NEVER use in or near swimming pools or other bodies of water.
  • To avoid tip over, place product on flat, level ground or floor.
  • To avoid possible entanglement or strangulation (Stage 1), remove toybar when baby begins to push up on hands and knees.
  • NEVER place play mat from stage 1 in the bottom of saucer in stage 2
  • STRINGS CAN CAUSE STRANGULATION! :
    • DO NOT place the ExerSaucer anywhere near cords from window blinds, draperies, phone, etc.
    • DO NOT place items with a string around your child's neck such as hood strings or pacifier cords.
    • DO NOT suspend strings over product or attach strings to toys.
  • Wash snack tray and snack tray area thoroughly prior to use.
  • DO NOT mix old and new batteries.
  • DO NOT mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. Only batteries of the same or equivalent type, as recommended, are to be used.
  • DO NOT use rechargeable batteries.
  • DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT recharge non-rechargeable batteries.
  • Promptly remove old batteries from the toy. Remove batteries before storing unit for a prolonged period of time.
  • Only use replacement parts supplied by Evenflo on this product.

Registration Information

Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your personal information. To register your product, please complete and mail the card that came with it or visit our online registration at www.evenflo.com/registerproduct.

www.evenflo.com
USA: 1-800-233-5921 8 AM – 5 PM E.T.
Canada: 1-937-773-3971
México: 01-800-706-12-00

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Evenflo Exersaucer Sweet Tea - Bouncing Activity Saucer Manual

Advertisement

Need Assistance?

Do you have a question about the Exersaucer Sweet Tea that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents