Getting Started
Installing New Batteries
NOTE: The UHF-388 requires 2 AA
rechargeable batteries.
To install:
•
Twist off the battery compartment
cover completely until the battery
slots are exposed (Fig. D).
•
Insert both batteries and make
sure that their polarities are
facing the proper direction
(Fig. E).
•
Reattach the battery compart-
ment cover twisting until it is
secure again.
Setting Up with Stage Monitors/P.A. System
If you will be using the UHF-388 with stage monitors and/or a P.A. system, try the following:
•
Place the stage monitor
directly in front of the
microphone.
•
Locate the P.A. loudspeakers
so that they point away from
the rear of the microphone.
(With the speakers located
in these positions, the pos-
sibility of feedback is greatly
reduced).
•
Always check the stage
setup before a perfor-
mance to ensure optimum
placement of microphone
and monitors.
IMPORTANT: Every wireless microphone installation is a unique situation, and can present a
variety of problems. Never attempt a live performance without first conducting a "walkthrough"
test of the system in the performing area. If major changes (additional wireless systems or
intercoms, relocation of scenery, etc.) have been made since the last walk-through test, check
the wireless system again, as close to performance time as possible.
UHF-3700
POWER
ON
OFF
Fig. D
Fig. F
7
�
�
Fig. E
PA Speakers Facing Away
From Rear of Microphone
Monitor Directly in
Front of Microphone