Getting Started
Caution: Before connecting the power supply, make sure that the power switch on the reciever
is switched OFF. Note:For additional protection, it is recommended that you plug in the power
supply to a surge protector/Power strip.
Setting Up the UHF-388
Set up the UHF-388's receiver in a spot where there are no barriers above the antennas or between the
receiver and the microphones. Make sure you have enough space above the receiver to charge the micro-
phones. NOTE: Do not place the UHF-388 in a space where there is something above the antennas such
as a rackspace or an entertainment center.
POWER
Connecting the Antennas
1.
Line up the slots on the antenna's BNC connector (Fig. B) with the
pegs on the receiver's BNC inputs (Fig. C) and push in.
2.
Twist the antennas BNC connector "clockwise" until it locks in to place
3.
Repeat steps 1 and 2 for the second antenna.
Fig. B - Close-up of Antenna BNC
CHANNEL A
CHANNEL B
CHARGING
CHARGING
UHF-388
ANT. A
RECHARGEABLE UHF WIRELESS MIC SYSTEM
ANT. B
CHANNEL A
POWER
ANT. A
CHANNEL B
Fig. C - Close-up of BNC Input on Face of UHF 388
6
CHANNEL B
CHARGING
CHARGING
UHF-388
RECHARGEABLE UHF WIRELESS MIC SYSTEM
ANT. B
ANT. B