Getting Connected - VocoPro UHF-3205 Owner's Manual

Getting connected

1. Connect the AC POWER ADAPTER to the UHF-3205 receiver's POWER INPUT connector, then plug the ADAPTER
into a compatible AC electrical outlet.
2. Attach the antennas by screwing in until secure. Be sure the antennas are pointing as straight up as possible.
3. Connect the UHF-3205's receiver to a sound system, mixer or amplifier's microphone input(s) with ¼" output
jacks.
NOTE: There are two options when connecting the UHF-3205 to a mixer or amplifier.
1. Independent Mic Channels
a. Connect each mic channel independently to separate input channels on a mixer or amp. Do this by
connecting a 1/4" cable from each mic channel (CH. A OUT and CH. B OUT) to individual inputs on your
mixer or amp.
2. Mixed Mic Channels
b. Use the mixed output to connect both microphone channels to a single mixer or amp channel. Do this by
connecting a 1/4" cable from the MIX OUT jack to an input jack on your mixer or amp.
Connecting
����
����
���������
�� �����
www.vocopro.com
������� ������
��� � ��� ��� � ��� ��� ���
�� ����� ����������
�� �� �
������
������
��
�����
�����
��������
8
V.CANCEL
V.PARTNER TAPE REC.
VOCAL CANCEL/PARTNER TAPE REC.
������ POWER
���������
������������ ��������� ��
���� ����������� ����� ������
CAUTION
!
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
CAUTION: TO PREVENT ELECTRIC SHOCK,
DO NOT REMOVE COVER SCREWS
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
PERSONNEL
������ ���
������
������
DSP ECHO
DSP SONIC
REVERB ENHANCER
LEVEL LOW HIGH