Samsung NSE6D 85 Series User Manual page 52

Maintaining your appliance
Before a self-cleaning cycle
Fig. 1 Fig. 1
Don't hand Don't hand
clean the clean the
oven door oven door
gasket. gasket.
You may You may
hand clean hand clean
the door. the door.
Fig. 2 Fig. 2
NOTE
Remove oven racks and accessories before starting the self-clean mode.
52 English
• We recommend venting your kitchen
with an open window or using a
ventilation fan or hood during the self-
cleaning cycle.
• Remove the wire rack, broil pan, broil
pan insert, all cookware, and any
aluminum foil from the oven.
• Wipe up debris from the oven bottom.
(Fig. 1)
• Residue on the front frame of the range
and outside the gasket on the door will
need to be cleaned by hand. Clean these
areas with hot water, soap-filled steel-
wool pads, or cleansers, such as Soft
Scrub. Rinse well with clean water and
dry.
• Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for
the gasket to remain intact. If you notice
it becoming worn or frayed, have it
replaced. (Fig. 2)
• Make sure the oven light bulb cover is in
place and the oven light is off.
How to run a self-cleaning cycle
1. Make sure the oven door is closed completely and unlocked. And turn off all
oven and cooktop function.
2. Tap , and select Cleaning > Self Clean using the dial knob.
Then, select the cleaning time. (2 hour / 3 hour / 5 hour)
3. Tap Start.
The oven door is locked automatically and the oven begins to heat up.
NOTE
• You will not be able to start a self-cleaning cycle if the oven lock feature is
activated or if the oven's temperature is too hot.
• The oven door locks automatically. The display will show the cleaning time
remaining. It is not be possible to open the oven door until the temperature
drops to a safe/cool temperature.
• The self-cleaning feature will not operate when the warming center is on.
4. When the self-cleaning cycle is done, End will appear in the display and the
range will beep several times.
How to delay the start of self-cleaning
1. Repeat steps 1 and 2 on 'How to run a self-cleaning cycle'.
2. Select Set Delay Start.
3. Set the time you want the oven to start self-cleaning using the dial knob.
4. Tap Start.
The oven will start self-cleaning at your specified time.