Optional Accessories (Sold Separately); Battery Removal/Installation - Hitachi Koki DS 12DVB2 Handling Instructions Manual

OPTIONAL ACCESSORIES (sold separately)

1. Battery (EB914, EB9B, EB9H, EB926H, EB930H)
(For DS9DVB2)
2. Battery (EB1214S, EB1214L, EB1220BL, EB1222HL,
EB1226HL, EB1230HL)
(For DS12DVB2)
3. Battery (EB1414S, EB1414, EB14B, EB1426H, EB1430H)
(For DS14DVB2)
4. Battery (EB1814SL, EB1820, EB1820L, EB1826HL,
EB1830HL)
(For DS18DVB2)
Optional accessories are subject to change without notice.
APPLICATIONS
Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals.
Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch (1
pc. or 2 pcs.) to remove the battery (See Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as follows.
〈 〈 〈 〈 〈 UC12SD/UC14SD/UC18SD 〉 〉 〉 〉 〉
1. Insert the battery into the charger
Insert the battery firmly while observing its direction,
until it contacts the bottom of the charger (See Fig. 3 ).
CAUTION
The UC12SD, UC14SD, and UC18SD models are the
exclusively designed chargers. These cannot charge
batteries except the specified batteries. It is possible
to insert the batteries other than the specified into
the chargers and some of them may light up the pilot
lamps. However, you are requested to exercise utmost
caution not to charge batteries other than specified
ones because these can not only be charged but also
such actions can result in the malfuntion of chargers.
2. Connect the charger power cord to the receptacle
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the power
cord from the AC outlet and check the battery
mounting condition.
About 60 minutes are required to fully charge the
battery at a temperature of about 20°C. The pilot
lamp goes off to indicate that the battery is fully
charged.
The battery charging time becomes longer when a
temperature is low or the voltage of the power source
is too low.
When the pilot lamp does not go off even if more
than 120 minutes have elapsed after starting of the
charging, stop the charging and contact your HITACHI
authorized service center.
CAUTION
If the battery is heated due to direct sunlight, etc., just
after operation, the charger pilot lamp may not light
up. At that time, cool the battery first, then start
charging.
3. Disconnect the charger's power cord from the
receptacle
4. Hold the charger firmly and pull out the battery
NOTE
After operation, pull out batteries from the charger
first, and then keep the batteries properly.
English
38