Example Of Display - DeLonghi TRD50615ECA Instructions For Use Manual

DESCRIPTION
A POWER ON/STANDBY button
B
timer button
C control dial
D display
E
wheel
F cord holder
Symbols shown on the unit's display
Key/child lock
power supply
temperature/clock
selected power levels
working power levels
Anti-freeze symbol
timer function
(green) Temperature 1 (T1) indicator
l
l (red) Temperature 2 (T2) indicator
FIRST USE
"Easy wheel" system
Turn the radiator upside down on a rug or a soft surface in
order to prevent damaging the paint finish.
Fully unfold the wheels by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
Fig. 1
Location
The heater must not be placed immediately below a power
outlet. Do not use this radiator in rooms having a surface area
of less than 43 square feet (4 sq.m.).
Power connection
Before using the appliance check that your supply voltage is
the same of that shown on the rating label of the unit and
that the power socket and power supply line correspond to
the load specified. After plugged in the appliance will show
the symbol in red color.
Setting the time
When using for the first time or after it has been unplugged
for a long time, you need to set the current time.
Please note: This is a 24 hour clock display. Example:
8am is displayed as 0800. 4pm is displayed as 1600. Keep that
in mind when setting clock and timer functions.
1. Plug the appliance into the outlet. The display will show
00 blinking.
2. Turn the control dial to select the current hour.
3. When the correct hour is set, press the dial and the min-
utes digits will blink.
4. Turn the control dial to set the minutes then press the
dial to confirm and you will hear a beep.

Example of display:

❶
❸
Changing the time
If you need to change the time, turn unit ON by pressing the
POWER ON button
5 seconds. Then, follow instructions 2 through 4 from "setting
the time" section above. After changing the clock, the unit
will remain ON."
MANUAL OPERATION MODE
Turn the appliance on pressing the POWER ON button
The unit will start operating in manual operation mode with
the following default settings:
6
❷
❹
. Then, press and hold control dial for
.