Timer Function; Brightness Of The Display - DeLonghi TRRS0715E Instructions For Use Manual

display will show symbol. If the selected temperature
is much higher than the actual room temperature, the
appliance will start automatically and rapidly to heat the
room.
The appliance will automatically select the most convenient
power level (MAX-MED-MIN-OFF).
If MAX power level has been selected using the
button, the appliance will cycle between: MAX-MED-MIN-
OFF.
If MED power level has been selected, the appliance will cycle
between: MED-MIN-OFF.
If MIN power level has been selected, the appliance will cycle
between: MIN-OFF.
Working indicator
The symbol indicates the heating status by means of its
colors.
RED: the unit is heating at the maximum power.
ORANGE: the unit is heating at the medium power.
GREEN: the unit is heating at the minimum power.
absent: the unit is not heating.
Key lock
In order to avoid accidental operation, you can lock the
keyboard using the keylock function. To activate this function
during on mode, press buttons + and - together for at least
3 seconds. The display shows the symbol
acoustic signal will be emitted. To disactivate the function
proceed in the same way.

Timer function

This function can be activated in two different ways.
Delayed start: With the appliance in standby mode, press
the timer button (G) . The hours left before the appliance
comes on is displayed together the
symbol flashing. Change the hours using the + and - buttons,
then wait a few seconds for the program to be stored.
The display will return to off and the
When the programmed time has elapsed, the appliance will
come on with the previous settings.
Delayed stop: with the appliance on, press the timer button
mode, the power level and in case the function selected are
displayed together with the
flashing. Change the hours using the + and - buttons, then
wait a few seconds for the program to be stored. The current
settings and
time the appliance switches to standby mode automatically. To
go back to operating without the timer, press the timer button
twice. The timer symbol
Change of the temperature scale
The display can show the temperature in both °F and °C.
To select the desired temperature scale, when the unit is in
standby position, press and hold the "+" and "ECO" keys for
at least 10 seconds, then release.
The change of scale will be indicated by two short beeps.

Brightness of the display

and a double
The appliance allows two different brightness settings for the
display. The highest is active when any key button is pressed.
After a few seconds of key board inactivity, the brightness will
decrease to the operating brightness level. This lower level
can be adjusted in this way:
-
symbol and "h"
symbols remains on.
-
-
5
. The hours left before the appliance goes to stand-by
symbol are displayed. At the end of the set
disappears from the display.
Please note: the time is settable from 0.5 to 24 hours.
with the appliance in on mode after pressing for 5
seconds the ECO button the display will show:
With the + and - button is possible to select the desired
brightness (three brightness levels available).
After 5 seconds without to press any button, the
brightness level will be memorized and the operating
conditions will be the same ones previously set.
symbol and "h" symbol