Using The Timer; Alarm; Configuring Alarm Settings; Turning Off An Alarm - Casio G-SHOCK MRG-B2000R-1A Operation Manual

Using the Timer

1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Press (A) to start the countdown.
Seconds
24-hour
Hours
Minutes
A beeper sounds for 10 seconds when the
end of the countdown is reached.
To pause an ongoing countdown, press
●
(A). To reset a paused countdown to the
start time, press (B).
3.
Press any button to stop the tone.

Alarm

The watch will beep when the alarm time is
reached.
The beeper is muted in the cases described
●
below.
When battery power is low
ー
While the watch is at Level 3 power
ー
saving
Power Saving
l
Operation Guide 5625

Configuring Alarm Settings

1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Loosen the crown and then pull it out to the
first click.
This turns on the alarm.
3.
Rotate the crown to change the alarm time
setting.
Minutes
Hours
4.
Push the crown back in and then lock it.
To stop the alarm
●
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
You can also use CASIO WATCHES
●
to configure alarm time settings.

Turning Off an Alarm

To stop the alarm from sounding, perform the
steps below to turn it off.
To have the alarm sound again, turn it on.
●
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (B) to move the second hand to
OFF.
Each press of (B) toggles between on
●
and off.
Alarm on
Crown
Alarm on
Alarm off
Adjusting Hand and
Day Indicator

Alignment

Strong magnetism or impact can cause the
hands and/or the day indicator to go out of
alignment. If this happens, adjust hand and
day indicator alignment.
The watch performs alignment of the hour
●
hand, minute hand, and second hand
automatically.
Adjusting Hand and Day
Indicator Alignment
1.
Loosen the crown and then pull it out to the
second click.
2.
Hold down (B) for at least five seconds
until the second hand points to 12 o'clock .
Release the button when the second hand
reaches 12 o'clock.
This will start auto alignment of the hour
hand, minute hand, second hand, and 24-
hour hand.
After auto alignment is complete, the
●
hands should be in the positions shown
below.
Second hand
Minute hand Hour hand
24-hour hand
3.
Press (C).
Confirm that the small hour and minute
hands, and the small 24-hour hand are all
stopped at 12 o'clock.
Small hour hand Small 24-hour hand
Small minute hand
4.
If the small hour and minute hands, and
the small 24-hour hand are not at 12
o'clock, rotate the crown to align them with
12 o'clock.
Crown
16