Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
If flash alert is enabled, display illumination
●
flashes along with the beeper at the end of
the countdown.
Configuring Flash Alert Settings
l
Using a Timer
●
Your watch provides you with two different
types of timers. Select the timer you want to
suit your needs.
Repeat Timer
●
With the Repeat Timer, countdown stops
and the start time setting appears when the
end of the countdown is reached.
The Repeat Timer comes in handy when
you need to perform the same countdown
operation a number of times.
Auto Repeat Timer
●
With Auto Repeat Timer, the countdown
operation is automatically restarted from the
start time when the end of the countdown is
reached. This continues until you stop the
countdown operation.
Watch Operation Guide 3529
Setting the Time
The countdown start time can be set in 1-
second units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Press (A).
This causes the hours digits to flash.
3.
Use (D) to change the timer hour setting.
Holding down (D) scrolls through
●
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
5.
Use (D) to change the timer minute
setting.
Hours
Minutes
6.
Press (C).
This causes the seconds digits to flash.
Seconds
7.
Use (D) to change the timer seconds
setting.
8.
Press (L) to select Repeat Timer or Auto
Repeat Timer.
Each press of (L) toggles between
●
Repeat Timer and Auto Repeat Timer.
[AUTO] is displayed while Auto Repeat
●
is enabled.
9.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Setting a start time of [0:00'00] will
●
perform a countdown of 24 hours.
10