MULTIQUIP QP4TB Operation Manual page 6

CAUTION
„ NEVER lubricate components or attempt service on a
running machine.
„ NEVER block or restrict fl ow from a discharge hose.
Remove kinks from the discharge line before starting
the pump. Operation with a blocked discharge line can
cause water inside the pump to overheat.
NOTICE
„ ALWAYS fi ll the pump casing with water before starting
the engine. Failure to maintain water inside the pump
housing will cause severe damage to the pump and
mechanical seal.
„ In winter, drain water from the pump housing to prevent
freezing.
„ NEVER start the pump with the clean-out cover removed.
The rotating impeller inside the pump can cut or sever
objects caught in it. Before starting the pump, check that
the clean-out cover is securely fastened.
„ ALWAYS keep the machine in proper running condition.
„ ALWAYS ensure the pump is on level ground before use.
„ Fix damage to the machine and replace any broken
parts immediately.
„ ALWAYS store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
PAGE 6 — QP4TB TRASH PUMP • OPERATION MANUAL — REV. #0 (01/11/24)
SAFETY INFORMATION
ENGINE SAFETY
WARNING
„ NEVER operate the engine with heat shields or
guards removed.
„ DO NOT remove the engine oil drain plug
while the engine is hot. Hot oil will gush
out of the oil tank and severely scald any
persons in the general area of the pump.
CAUTION
„ NEVER touch the hot exhaust manifold,
muffl er or cylinder. Allow these parts to cool
before servicing the equipment.
NOTICE
„ NEVER run the engine without an air fi lter or with a dirty
air fi lter. Severe engine damage may occur. Service the
air fi lter frequently to prevent engine malfunction.
„ NEVER tamper with the factory settings of
the engine or engine governor. Damage
to the engine or equipment can result
if operating in speed ranges above the
maximum allowable.