Advertisement
Adjustment
@ Open.
Arm clamp
4. Check to be sure the automatic-start position is correct.
§. Attach the dust cover.
Replacement of the cartridge .
If noise is heard from new discs, the stylus is probably worn.
The plug-in type of cartridge
is already designed to match
Replace it with a new one.
this unit in every respect: weight, correct stylus pressure, stylus tip
© StYIUS VEO ccc cccccccccsesssesssevessevessscescnsecesnsenne approx. 1000 hours
position, center of gravity, etc. This means that there's no longer
New stylus
EPS-24CS
any need for troublesome connection of lead wires or adjustment
Te
tah
Re
Perea
Ph
TE
of the stylus pressure.
@ Remove the tape on side of cartridge.
@ Pull out
@® Insert the
Clamp the
the old stylus.
new stylus.
tonearm.
:
Zab
@ Insert the new
=
cartridge by
Q)
+
4
following the
/' No gap!
@ Pulloutthe
steps in
Don't touch stylus tip!
@® Remove the screw.
cartridge.
reverse order.
Maintenance
Use a soft brush or similar material to gently remove the dust.
To clean this unit, use a soft, dry cloth.
Thoroughly clean your discs occasionally with a high-quality disc
If the surfaces are extremely dirty, use a soft cloth, dipped into a
cleaner.
soap-and-water solution or a weak detergent solution.
Wring the cloth well before wiping the unit.
Wipe once again with a soft, dry cloth.
Never use alcohol, paint thinner, benzine, nor a chemically treated
cloth to clean this unit.
Such chemicals may damage the finish of your unit.
2
\ Carefully. . .in arrow direction!
Advertisement
