Technics SL-J110R Operating Instructions Manual page 4

.
f t | Nn Note: Turn the amplifier on, and set it for listening to the sound.
(Reter to the operating instructions of the amplifier.)
Remove the stylus protector.
Dust cover is the standard mark for the "P-mount" plug-in-
connector system. Products carrying this mark are inter a
Open the dust cover. changeable and compatible with each other, ww" Protector
(The tape on side of cartridge prevents the stylus
assembly from shaking loose during shipment.)
Platter mat
3 Arm clamp
4 Place a disc
Remove the
arm clamp.
on the platter mat.
45-rpm adaptor Arm clamp
For a 17-cm (7")
{large center hole)
Raise 45-rpm adaptor by
pressing and turning
counterclockwise. The
adaptor will then pop up.
(When the adaptor is not
needed, press down and
turn clockwise.)
yom
Set to "W'"' to stop the play
temporarity.
Set to "Wi" to resume the
play.
Record size detector
Detects the size of the
record on the platter
automatically.
Press to stop the play.
rs Start/stop switch (START/STOP)
5 Press.
Speed selector (The i i i
platter will start turning, then play will start.)
(SPEED)
- 6
Cueing switch (CUEING)
(The tonearm won't move if there is no disc on the
Set to disc's speed. Set to "W"'. platter mat.)
Manual play i Notes
The following types of discs should be played manually.
1, While the tonearm is moving, don't touch the tonearm.
e Discs other than 17- or 30-cm discs
2. The platter may start turning or keep turning in some cases like
@ Lightweight discs such as ''Soundsheets"'
those listed below. Press the start/stop switch is to make the
e Badly warped discs platter stop.
1. Follow the step 1—5 of the automatic play. @ When the power cord is connected.
2. Set the cueing switch to the "wr position,
¢ If the start/stop switch is pressed when there is no disc on the
3. Move the tonearm to the desired position. platter mat.
(The platter will start turning.) 3. It may happen, in combination with the Technics equipments
4. Set the cueing switch to the "W."' position.
with the remote control function, that play starts when the stop
button (in the turntable system section of the remote-control
transmitter) is pressed while the tonearm is returning. If this
| After use happens, press the stop button once again.
4 ates fl 3
1. Clamp the tonearm. If the recording is made by using the synchro recording
2. Attach the stylus protector method, it may happen, depending on the disc, that the