Advertisement
Adjustment
AdliMtmeni of the
This adjustment is preset at the factory. If play starts from the middle of a tune, or the stylus descends outside the disc circumference, make
the necessary adjustment.
1. Clamp the tonearm.
2. Remove the dust cover.
3. Adjust to the desired automatic-start position.
4. Check to be sure the automatic-start position is correct.
5. Attach the dust cover.
Replacement
Replacement of the sty
If noise is heard from new discs, the stylus is probably worn.
Replace it with a new one.
• Stylus life.approx. 1000 hours
• New stylus.EPS-24CS
© Remove the tape on side of cartridge.
© Pull out
the old stylus.
© Insert the
new stylus.
/No gap!
Don't touch stylus tip!
Maintenance
The plug-in type of cartridge FHPi is already designed to match
this unit in every respect: weight, correct stylus pressure, stylus tip
position, center of gravity, etc. This means that there's no longer
any need for troublesome connection of lead wires or adjustment
of the stylus pressure.
© Clamp the
tonearm. ,
x
© Pull out the
© Remove the screw.
cartridge.
'■ © Insert the new
cartridge by
following the
steps in
reverse order.
Use a soft brush or similar material to gently remove the dust.
Thoroughly clean your discs occasionally with a high-quality disc
cleaner.
To clean this unit, use a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth, dipped into a
soap-and-water solution or a weak detergent solution.
Wring the cloth weil before wiping the unit.
Wipe once again with a soft, dry cloth.
Never use alcohol, paint thinner, benzine, nor a chemically treated
cloth to clean this unit.
Such chemicals may damage the finish of your unit.
-
5
-
Advertisement
