Hatco FLAV-R-SAVOR FSD Series Original Instructions Manual page 15

Symptom
Fluorescent lamp not working.
Unit operates, but is not circulating air
inside cabinet.
Unit is plugged in, but nothing works
Unit is operational, but rotating rack (if
equipped) does not turn.
Unit is not producing any "hot air"
inside cabinet.
Unit is heating, but is not producing
humidity inside cabinet. "LO H20" not
flashing on display and unit is full of
water.
Unit is heating, but is not producing
humidity inside cabinet. "LO H20"
flashes on display and unit is full of
water.
Error Codes
The following error codes may appear on the digital display to
indicate an error in the operating condition of the unit.
LO H20 = Low water probe does not detect water. Refill water
reservoir — refer to instructions in OPERaTION
section of this manual.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please contact the nearest authorized Hatco Service agency or Hatco for
assistance. To locate the nearest Service agency, log onto the Hatco website at www.hatcocorp.com and click on
Find Service Agent, or contact the Hatco Parts and Service Team at:
Telephone: 414-671-6350
e-mail: partsandservice@hatcocorp.com
Form No. FSDCEM1-0916
Probable Cause
Lamp loose or defective.
Ballast failed.
Blower motor is defective.
The correct voltage may not be supplied to blower. Contact an authorized Hatco Service agent or Hatco
No power to unit.
Power cord connections
disconnected.
Power cord is damaged.
Defective POWER ON/OFF (I/O) switch.
Proximity switch was not relocated after door
reversal.
Proximity magnet or proximity switch not working
properly.
Incorrect voltage is supplied to rack motor.
Rack motor is defective.
Safety high-limit is tripped or open.
Incorrect voltage supplied to heating element.
Blower motor is not working.
air heating element is defective.
Incorrect voltage supplied to water heating
element or heating element is defective.
When using distilled water, no minerals are being
sensed by low water probe.
Low water protection system is malfunctioning.
TROUBLESHOOTING GUIDE
Re-install or replace fluorescent lamp.
Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
for assistance.
Check electrical receptacle and verify that power
supply matches specifications on unit. If receptacle is
not working, check circuit breaker and reset, or plug
unit into a different known working receptacle.
are loose or Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
See "Relocating the Proximity Switch" in the
INSTaLLaTION section of this manual.
Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
Contact an authorized Hatco Service agent or Hatco
for assistance.
On initial fill, add 5 g (1 Tsp) of salt to the water
reservoir.
Contact an authorized Hatco Service agent or Hatco
for assistance.
E1 = air temperature sensor malfunctioning. Contact an
authorized Hatco Service agent or Hatco for assistance.
E2 = Humidity temperature sensor malfunctioning. Contact an
authorized Hatco Service agent or Hatco for assistance.
15
Corrective Action