Software Installation; Installation Verification - HP 3000 Series Installation And Service Manual

Installation
f. If a direct INP-to-SSLC connection is being made (from your
local computer with its INP to a remote computer with an
SSLC), route the external INP-to-SSLC direct-connect cable
(part no. 30225-60003) directly to the remote computer. Con-
nect the other end of the external direct-connect cable to
the remote computer's modem inte rconnecting cable (completely
bypassing all modems).
2-8. SOFTWARE INSTALLATION
The INP has been preprogrammed at the factory and requires no
field programming. All INP software, including the se~f test, is
contained within the circuitry of the INP PCA board. Therefore,
no separate software installation procedure is required.
The diagnostic software (DSM) used for troubleshoot ing INP prob-
lems is separate from the INP's own software. This diagnostic
program is included with your updated operating system and, like-
wise, requires no separate software installation procedure.
2-9. INSTALLATION VERIFICATION
Verify that the INP has been properly installed and that it now
functions accordingly as follows:
a. Turn on the power.
On the HP 3000 Series 30, return the POWER switch to the ON
pos i tion.
On the HP 3000 Series 33, return the PROCESSOR switch to
the ON position.
b. Power up the system in accordance with the HP 3000 Series
30/33 Console cpera tor's Guide.
c. Pres s the red, spr ing-loaded RESTART sw itch on the edge of
the INP PCA board (figure 2-6) to manually initiate the self
test.
d. Watch the self-test light-emitting-diode (LED) indicators
(figure 2-6) as the self-test program goes through its cycle.
Upon completion of the self test (approximately 2 seconds in
duration), the LEDs will stop winking and will display a
steady pattern. If the two LEDs at each end (0 and 7) are
lighted while all the others are off, the INP is working
properly. If any other pattern of lighted LEDs is being dis-
played, the INP is malfunctioning.
2-12