Elektra Beckum TopLine TKHS 315 E Operating Instruction page 34

2. Hold a straight edge to the side of the saw
blade.
3
Since the blade's teeth are bend alternately to
the outside (= set of saw teeth), ensure that
the straight edge does not touch a tooth set to
the right, else the straight edge will not be
exactly parallel with the saw blade.
3. Setting the scale: The scale's "0" mark must be
exactly under the left edge of the straight edge.
4. Tighten the pan head tapping screw carefully
and remove the straight edge.
Combination rip/crosscut fence assembly
Qty. Description
1 Stop rule, upper
1 Stop rule, lower
1 Hexagon head screw M6 x 130
1 Hexagon nut, prevailing torque
type M6
1 Pressure spring
1 Clamping pad
3 Knurled nut M6
1 Hexagon head screw M8 x 30
1 Washer A8.4 x 17
1 Starknob nut M8
2 Cross recessed flat head screw St
4.8 x 22
2 Cup square neck screw M6 x 30
1 Fence extrusion
1 Fence extrusion end piece
2 Washer A6.4
1 Spacer plate
2.13
1. Put the hexagon head screw M6 x 130 from the
top into the guide tube of the lower stop rule.
2. Screw on a prevailing torque type hexagon nut
for at least 65 mm.
The best way to screw on the nut is to turn the
hexagon head screw, pulling it up at the same
time. This way the nut is held in the guide tube.
3. Put the pressure spring and clamping pad onto
the hexagon head nut as illustrated and screw
on the knurled nut M6.
4. Put the upper stop rule with the round stud into
the corresponding hole in the lower stop rule.
Item
5. Put the hexagon head screw M8 x 30 from
91
below into the lower stop rule: the threaded end
87
of the screw must reach through the oblong hole
88
in the upper stop rule.
68
6. Put a washer on the hexagon head screw M8 x
30 and screw on the starknob nut M8.
86
7. Fit the end piece to the fence extrusion and
85
secure in place with the two flat head screws.
84
8. Put both cup square neck screws through the
89
spacer plate as illustrated and slide them, with
6
the spacer plate, into the outer groove of the
90
fence extrusion.
96
9. Attach the fence extrusion with the two knurled
nuts and washers to the upper stop rule.
93
10. Attach the lower stop rule to one of the two
94
guide bars by tightening the knurled nut:
- short guide bar
95
- long guide bar
65
92
Accessory storage hook installation
Qty.
2 Hexagon socket head cap screw
M8 x 30
4 Hexagon nut M8
1 Push stick
– rip fence
– crosscut/mitre fence
Description
TKHS 315 E
Item
5
4
100