XA0030E.fm Operating Instruction ENGLISH ENGLISH 1. Getting to Know Your Saw Suction hose Mains connection Accessory storage hook Sliding plate (on the under- side) Blade tilt lever Dust extraction port of chip Twist handle for locking the case assembly blade tilt angle Table insert Bevel tilt scale Saw blade guard with dust...
ENGLISH jigs or fixtures. The rotating saw blade Do not use the power cable for purposes Table of Contents could turn the workpiece. it is not intended for. Getting to Know Your Saw ..11 Any other use is considered to be not as Risk of personal injury and specified and not allowed.
ENGLISH devices or slightly damaged parts must (optional accessory) less than Setting device for saw blade tilt be inspected for proper functioning as 120 mm. With the swivel arm (19) the saw blade is specified. Check to see that all moving steplessly tilted from 0°...
ENGLISH Attaching the four leg to the inside of Installation of switch for 110 V 2.2 kW The underside of the blade guard Motor the table panel’s corners: should be in a horizontal position. − fit hexagon head screws (25) into Loosen both hexagon head screws holes from the outside;...
ENGLISH − mains voltage and system fre- − Never cut several workpieces at of cut only with the saw blade at quency conform to the voltage the same time – and also no standstill! and frequency shown on the bundles containing several indivi- The saw blade’s depth of cut needs to saw’s rating label;...
ENGLISH Loosen arbor bolt (50) with spanner Set required blade tilt with the blade 10. Screw arbor bolt (51) back in the (L.H. thread!). tilt lever (43). saw spindle (L.H. thread!) and Remove outer blade collar (49) and Lock the set bevel angle by tighten- tighten it.
ENGLISH Saw Blade KV 56 ∅315 Lateral alignment: Every 300 hours of operation riving knife and saw blade must be per- For rip and cross cuts in grown tim- Check all screwed joints, retighten if fectly in line. ber and particle board. necessary.
− Have power supply checked by a Chip build-up in the chip case qualified electrician. No dust collector or one of insufficient suction capacity connected: 15. Technical Specifications TKHS 315 E/P TKHS 315 E/P TKHS 315 E/P TKHS 315 E/P TKHS 315 E/P 2200 WNB...