Page 2
által végzett vizsgálat szerint megegyezik az alábbi építési mintapéldánnyal *** a **** TKHS 315 E/P TKHS 315 E/P TKHS 315 E/P TKHS 315 E/P *EN 1870-1, EN 60204 *** BM 9410359 02 Jürgen Kusserow Vorstand ELEKTRA BECKUM AG – Daimlerstraße 1 – 49716 Meppen 1001028/01...
Danger! Risk of electric shock! Risk of personal injury and crushing by moving parts! Cutting hazard, even with the cutting tool at standstill! Risk of kickback (workpiece is caught by the saw blade and thrown against the operator): Drawing-in/trapping hazard!
Risk of electric shock! Risk of personal injury by elec- tric shock. Drawing-in/trapping hazard! Risk of personal injury by body parts or clothing being drawn into the rotating saw blade. Caution! Risk of material damage. Note: Safety devices Riving knife...
Setting device for saw blade tilt (18) (19) Handwheel for setting the depth of (20) Fence (21) (22) (23) 6. Assembly Danger! Modifications of the saw or the use of parts not tested and approved by the equipment manufacturer can...
Page 7
For shipping the riving knife is is lowered beneath the table top's surface. Prior to initial operation the riving knife therefore needs to be adjusted: in the distance to the saw blade; in its lateral alignment. (33) (34) (34) (35)
This saw may only be operated by one person at a time. Other per- sons shall stay only at a distance to the saw for the purpose of feeding or removing stock. Before starting work, check to see that the following are in proper work- ing order: power cable and plug;...
Page 10
Setting the depth of cut Danger! Parts of the body or objects in the setting range can be caught be the running saw blade! Set the depth of cut only with the saw blade at standstill! (68) Note: Setting the saw blade tilt...
Danger! Directly after cutting the saw blade can be very hot – burning haz- ard! Let a hot saw blade cool down. Do not clean the saw blade with com- bustible liquids. Risk of injury, even with the blade at standstill. Wear gloves when changing blades.
Danger! Before carrying out any fault service or maintenance work, always: switch machine OFF; unplug power cable; wait for saw blade to come to standstill. Check that all safety devices are operational again after each fault service. Motor does not run...