Installing a 2.5" Hard Drive to the Hard Drive Tray
1. Pull the lever a little bit toward the left side to remove it from the locked position.
2. Open the lever.
3. Place the 2.5" HDD into the tray with the printed circuit board side facing down.
Carefully align the mounting holes in the hard drive and the tray.
4. Secure the hard drive using the screws.
5. Close the lever.
6. Push the lever a little bit toward the right side and make sure it's locked.
2
5
3
1
6
4
4
4
4
7. Slide the drive tray into the HDD bay until the drive is fully seated.
8. Push in the locking lever to lock the HDD tray into place.
7
8
20