Electrolux EI30DS5CJS2 Manual page 3

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with an Electric Oven and a Gas Cooktop)
To avoid breakage: Do NOT handle or manipulate the
unit by the cooktop.
c The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabinet
sides (H1-4), front and back (Illustration 1) from the floor to the top of
the counter.
Level the range using the Shave 1 Vo" Max.
two (2) front leveling legs Raised (3.8 cm Max.)
and the two (2) adjustable
ge or
o e
leveling wheel, so that
Space for
H2
the height from the floor
a 31%"
Ss
to the underside of the (81 cm) Wide
metal flange is greater Cooktop.
than the tallest cabinet
measurement by at least 1/16" (see Ill. 2).
Remove and discard the two rear leveling legs, they are only in
place to solidify the unit for the transport. Illustration 1
Slide the unit into the cabinet. Make sure the center of the unit is aligned with
the center of the cabinet cut-out.
Remove the protective channels on each side of the cooktop (if provided).
The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The cooktop
should NOT rest directly on the countertop (see illustration 2) or else
it could cause damage to the cooktop voiding the warranty. Level
the unit if needed.
~ To successfully
install the
range, the initial
level height
from floor to
underside of
cooktop frame
should be at
least 1/16"
taller than
cabinet sides
as measured in
supported by the two front leveling legs and the two' step 2.
oO After the installation, MAKE SURE that the unit is
adjustable leveling wheels and NOT by the cooktop
Illustration 2