3.
Secure the lower roll bar assemblies to the
upper roll bar assembly using the 2 shoulder
bolts, 2 wave washers, 2 locknuts (1/2 inch),
and fold-pin assembly
Figure 3
1. Upper roll bar assembly
2. Fold-pin assembly (fold
pin, lanyard washer, and
hairpin cotter)
3. Locknut (1/2 inch)
4.
Torque the 2 shoulder bolts and 4 flange-head
bolts (5/8 x 3-1/2 inches) on the lower roll bar
assemblies to 122 to 136 N∙m (90 to 100 ft-lb).
5.
Install the previously removed fenders and
fasteners.
6.
Install the previously removed rear styling side
brackets (if removed).
7.
Connect the negative battery cable.
(Figure
3).
g331075
4. Wave washer
5. Shoulder bolt
6. Lower roll bar assembly
5