Table of Contents
Advertisement
2
Removing the Existing
Rollover Protection System
(ROPS)
No Parts Required
Procedure
1.
Disconnect the negative battery cable.
2.
Remove and discard the upper roll-bar tube and
its hardware from the lower tubes.
3.
On the left side of the machine, remove and
retain the fuel cap and hardware attaching the
fender to the frame.
4.
Remove the fender from the machine.
Retain the fender.
5.
Install the fuel cap to prevent debris from getting
in the tank.
6.
On the right side of the machine, remove and
retain the hardware attaching the fender to the
frame.
7.
With the control panel still attached to the fender,
remove the fender and set it on the tire.
8.
Remove and retain the rear styling side brackets
(if equipped).
9.
Remove and discard the hardware attaching the
lower roll-bar tubes to the frame.
10.
Carefully remove and discard the ROPS from
the machine.
3
Advertisement
Table of Contents
