Preparation Before Operation - Daikin MC80ZBFVM3 Operational Manual

Read First

Preparation Before Operation

1 Checking Accessories
Attach to the unit before operation.
2 Positioning The Unit
Before setting up, remove the fixing tape on
the bottom which is securing the power supply
cord, then take out the power supply cord.
Remove the fixing tape on the pre-filter (front)
as well.
Pre-filter
(front)
At least
100cm from
the ceiling
At least
30cm from
the wall
Air flow
※
Please leave some distance from the wall to ensure power supply cord does not bend forcibly. (risk of damage and
overheat)
13
Tape [blue]
Power supply
cord
At least
30cm from
the wall
Deodorising filter ......... 1 unit
Operation manual (beneath the unit).....1 unit
Pointers for good positioning
• Choose a position from which airflow can reach all areas of
the room.
• Place on a stable surface. If the unit is placed on an unstable
surface, vibrations from the unit may be amplified.
• If interference from the power circuit inside the unit or cables
causes disturbance on your TV screen images or the
emission of static noise from nearby radios or stereos, move
the unit to at least 2m away from the device.
Keep cordless phones and radio-controlled clocks away
from the unit also.
• This unit contains radio transmitter; the minimum separation
distance between the radiating part of the equipment and
the user is 30 cm.
Attention
• To avoid staining of walls, position the unit in accordance
with the positioning measurements in the illustration.
However, please note that since this unit draws in dirty air,
certain types of wall may be stained even if the
measurements are adhered to. In such cases, make sure
to maintain sufficient distance between the unit and the
wall.
• When used for a long period of time in the same location,
the floor and surrounding walls may get stained as air is
drawn into air inlets near the base of the unit. It is
recommended to clean the unit periodically.
• Place the unit on a flat surface.
WARNING
Be sure to stop operation and remove
the power supply plug before installation.
(Electric shock or injury may result)