When Using - Panasonic NE-7910 Service Manual

« When Defrost is selected after Auto Sensor Cooking is selected.
e When 3rd stage cooking is selected.
e When clock is set later than 12:59 or at impossible time like 00:73 or 83:25.
Touch RESET Pad to clear "'E" from Display Window and enter correct instructions.
2.
© MNOS &
10.
11.
12.
lf Auto Sensor Control should not work properly, oven is designed to shut off automatically 60 minutes after operation
begins and to show "FFFF" in the Display Window. Touch RESET pad and complete the cooking by power and time.
If auto sensor control is open the oven will shut off automatically approximately 15 seconds.
—
AutoC@
Defrost !
Power C> OQ (am) OQ oO
High M.High Med M.Low Low Warm
Autoc>
Defrost >
Power'C>) Oo oO
High "Hi M.Low Low
(Fig. 5)
CAUTION WHEN USING
. Do not use metalware
In rare cases where you must use metal materials such as foil or skewers, etc., take care not to have the edge of the metal
material touch the inner glass screen, or the oven walls (coated steel), because the glass plate may be broken the coated
part may be burned by sparking.
Always keep the glass cooking tray clean
Do not cook foods with a high fat or sugar content directly on the glass tray.
. Do not dry clothes in the microwave oven.
. Avoid using wooden containers for more than a few seconds.
Do not operate the oven with a kitchen towel or a napkin left between the door and the front wall of the oven.
Do not press the cook button when the oven is empty.
Keep the inside of the oven clean.
Avoid cooking a small-volume of food for a long period of time.
If any visible steam or moisture is found on or around the door just wipe it off. There is no need for concern and this
never causes any microwave leakage.
Cautions when operating the control panel.
A. Do not touch contro} pads with water or oii on your finger.
When the control panel is dirty, wipe with a damp cloth first and then finish with a soft dry cloth. Do not use harsh
detergents or abrasives.
B. Do not try to touch the pads while wearing gloves or while holding any insulating materials.
C. For most accurate programming of the unit, tap the center of each pad or push the center of each button firmly.
D. Do not hit or strike the control panel since this is made of glass and may be broken.
When removing the roller-ring from. turntable for cleaning, be sure to re-install into the proper position. Avoid exposing
your watch to the magnetic-capsules located on the bottom of the turntable, or your watch may be damaged.
When power select is set at a setting other than High, the intensity of the oven lamp will vary. This is normal and
indicates that the oven is operating normally.
—~10—