Roland DM-80 Owner's Manual page 37

For Germany
Bescheinigung des Herstellers/Importeurs
Hiermit wird bescheinigt, daß der/die/das in Übereinstimmung mit den Bestimmungen der
Roland MULTI TRACK DISC RECORDER DM-80 Amtsbl. Víg 1046/1984
зов ине анан ваен ов оов аве ө о жө өэ эз өө өз везао» везана ово виза КОСЕ
(Gerät. Typ. Bezeichnung) (Amtsblattverfügung)
funk-entstórt ist.
Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerátes angezeigt und die Berechtigung zur Überprüfung
der Serie auf Einhaltung der Bestimmungen eingeráumt.
Roland Corporation Osaka/Japan
осо Creer eee eee ee вв а eee eee а ө э э а э вз э тө я э аэ eee өэ эз eee чина
Name des Herstellers/Importeurs
For the USA
RADIO AND TELEVISION INTERFERENCE
WARNING — This equipment has been verified to comply with the limits for a Class B computing device, pursuant to Subpart J, of Part 15, of РСС rules. Operation with
non-certified or non-verified equipment is likely to result in interference to radio and TV reception. |
The equipment described in this manual generales and uses radio frequency energy. If Й is not installed and used property, that is. in strict accordance with our instructions,
it may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class В computing device in accordance
with the specifications in Subpart J, of Part 15, of FCC Rules. These rules are designed to provide reasonable protection against such a interference in a rasidential installation.
However, there is no guarantee that the interference will nct occur in a particular installation. If this equipment does cause interference to radio or television reception, which
can be determined by tuming the equipment on and off, the user is encouraged to try to correct the interference by the following measure: 5
е Disconnect other devices and their input/output cables one а! a time. If the interference Stops, it is caused by either the other device or its ИО cable.
These devices usually require Roland designated shielded ЏО cables. For Roland devices. you can obtain the proper shielded cable from your dealer. For non Roland
devices, contact the manufacturer or dealer for assistance.
If your equipment does cause interference to radio ог television reception, you can try to correct the interference by using one ог mora of the fotowing measures.
Тит the TV or radio antenna until the interference stops.
Move the equipment to one side or the other of the TV or radio.
Move the equipment farther away from the TV or radio.
Plug the equipment info an outlet that is on a different circuit than the TV or radio. (That is, make certain the equipment and the radio or television set are on circuits con-
trolled by different circuit breakers or fuses.)
Consider installing a rooftop television antenna with coaxial cable lead-in between the antenna and TV. If necessary, you should consult your dealer or an experienced
radiofelevision technician for additional suggestions. You may find helpful tha following booklet prepared by the Federal Communications Commission:
"How to Identify and Resotve Radio — TV Interference Problems"
This booklet Is available from the U.S. Govemment Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.
For Canada
CLASS B NOTICE
This digital apparatus does not exceed the Class B limits for radio noise emissions set out in the Radio Interference
Regulations of the Canadian Department of Communications.
CLASSE B AVIS
Cet appareil numérique ne dépasse pas les limites de іа classe B au niveau des émissions de bruits radioélectriques fixés
dans le Réglement des signaux parasites par le ministére canadien des Communications.