Table of Contents
Advertisement
cr)
Tum the power on, and Insert a recorded video cassette.
1. Usually set the AUDIO MONITOR switch to MIX.
(if you want to hear only the sound on the audio channel 1, set the switch
to
CH-1; if you want to hear only the sound on the audio channel 2, set
it to
CH-2,)
'eThis switch has no effect on the sound output from the LINE OUT Jacks.
2. Press the PLAY button. Playback will begin.
0 oo |§
Q 8866):
To stop playback, press the STOP button.
1
2
TO STOP THE TAPE MOMENTARILY DURING PLAYBACK
Press the PAUSE button. The tape stops and a still picture will appear on the
monitor screen. To resume playback, press the PAUSE button again or press the
PLAY button,
The long pause mode
If the pause mode continues for about 8 minutes, the tape around the head
drum automatically slackens to protect the video head and the tape, and the
still picture disappears. This is called the long pause mode,
USING A TIME BASE CORRECTOR
The best possible playback picture can be obtained when a
time base corrector Is used. Connect the time base corrac-
tor as illustrated below, and set the TBC switch to ON.
For details on the operation of the time base corrector,
refer to the instruction manual furnished with it.
Time base
corrector
to SC output connector
to ADV SYNC
output connector
VO-5800PS
to ac outlet
—
TO.PLAY A-TAPE BACK WITH AN
EXTERNAL SYNC SYSTEM
Connect a syne signal or a composite video signal to
the VIDEO 1 or VIDEO 2 connector, and set the INPUT
SELECT
switch to LINE
and
the VIDEO
1/VIDEO 2
selact switch to the position corresponding to the con-
nector used. In other cases, the VO-S800PS operates
with an internal sync system.
SEARCH OPERATION
A particular point can be quickly located with the search
dial.
Press the SEARCH button and turn the search dial to look
for the point you want to locate. The search dial allows you
to vary the playback speed from 'fe to 5 times the normal
playback speed in both directions. Set the search dial to the
center "0" position at the point. The tape stops and a stitl
picture can be seen on the monitor.
Notes
During search operation, the servo system is not locked,
$0 guard band noise flows on the playback picture.
When
the video signal Is connected
using the DUB con-
nectors, the E-to-E mode picture on the monitor connected
to the recorder may rol! vertically when the player {$ in the
pause or search mode.
When
the video signal is connected using.the VIDEO con-
nectors, the color of the E-to-E mode picture on the monitor
connected to the recorder may be lost when the player Is In
the search mode.
If this happens,
set the COLOR
LOCK
switch to elther upper or lower position.
elf the TBG switch is set to ON but a time base corrector is
not connected, the vertical sync does not lock in the search
mode and the picture rolls vertically.
a)
Advertisement
Table of Contents
