Ctg Software - Shure EXHIBIT 212 Manual

Case: 1:17-cv-03078 Document #: 901-3 Filed: 08/12/20 Page 598 of 609 PageID #:48614
Page 18

CTG Software

To load and use setup software, connect USB cable to front panel data port,(see illus. D)
(Illus. D)
The CTG Audio Setup Utility is designed to help you control the audio levels coming in
and going out of your CTG product. This utility will:
1) Identify the CTG device you are using and indicate whether it's connected (or not
connected).
2) Set the audio levels to a comfortable default value. Once you modify the levels the unit
will save and restore your preferred levels anytime you connect a unit or open the audio
utility (you can choose not to save your settings and to go back to the default values).
3) The utility will allow you to control the level of signal going to and coming back from
your telephone. It will also allow you to control the level and balance of the bridge (the
connection between your telephone counterpart and VoIP counterpart in PSTN versions)
This utility is not necessary in order to use your CTG system. Some audio levels (VoIP)
can be controlled through your Windows mixers while others that are not controlled by
Windows (telephone and bridge) are set to a comfortable default level. However, this
utility adds another level of control that some users prefer to have.
An important feature of the utility is the ability to disable / enable the bridge connection.
This is intended to prevent your telephone counterpart from hearing unwanted sounds
coming out of your computer.
The software must be installed to a laptop or desktop computer running Microsoft
Windows 98 or newer, and connected to the FS-400 or FS-800 mixer with the provided
USB cable to the front Data Port on the mixer. The indicator will turn from Red to Green
and indicate the device is connected. If you already have an older version of the CTG
18
PGR2020-00079
Shure v. ClearOne
Page 19 of 26 ClearOne Ex. 2169