Installation Requirements; Tools And Parts; Location Requirements - Kenmore 66513734K604 Installation Instructions Manual

INSTALLATION REQUIREMENTS
POP oy yoy bye gtong upry pike EE pomp ups P a g e r
Tools and Parts
Gather the required tools and parts before starting installation.
All installations
Tools needed: m Small level
m Pliers mg Flashlight
mg Phillips screwdriver m= Shallow pan
gm %eé' and 4" nut drivers or mm %" open-end wrench
hex sockets mg Bath towel
Measuring tape or ruler Bm Wood block
m 10" adjustable wrench that Parts Needed:
t o 1%" (2.9
opens to 178 (2.9 em) mw Shims (if installed with
gm Flat-blade screwdriver built-up floor)
m Utility knife m %" Compr x 94" hose
MH 2 twist-on wire connectors fitting. Contact your local
Sears Store to purchase Kit
Number 11000.
which are the proper size to
connect your household
wiring to 16-gauge wiring
in dishwasher
In addition, for new installations
Tools needed: Parts needed:
m= Cordless drill with ¥2", 4", m@ ~=Copper tubing (%"
and 11" hole saw bits recommended) or flexible
= = Small tubing cutter stainless steel braided fill
ine
gm Wire stripper
PP m Clamp connector or
conduit connector to fit a
7/3" (2.2 cm) diameter hole
m 112" to 2" screw-type clamp
if connecting to waste-tee
Parts supplied
A. 2 — drain hose clamps, | large and 1 small
B.2-—#10x YY." Phillips-head screws
C. Drain hose
D. 2 — undercounter side mount brackets
E. 2 — undercounter mounting brackets (top)
Make sure all these parts are included. If not included, call
1-800-4MY-HOME.
See separate parts list for accessories available for your
dishwasher.
&
Gt ll Gon als BH
Do not run drain lines, water lines or electrical wiring where they
can interfere with or contact dishwasher motor or legs.
The location where the dishwasher will be installed must provide
clearance between motor and flooring. Motor should not touch the
floor.
Do not install dishwasher over carpeted flooring.
Shelter dishwasher and water lines leading to dishwasher against
freezing. Damage from freezing is not covered by the warranty.
A side panel kit is available from your dealer for installing your
dishwasher at the end of your cabinetry.
A moisture barrier accessory (Part Number 4396277) is available
from your dealer for installing underneath the countertop. This may
also be obtained by calling 1-800-4MY-HOME.
Check location where dishwasher will be installed. The location
must provide:
mM easy access to water, electricity and drain.
HM convenient access for loading and unloading dishes. Corner
locations require a 2" (5.1 cm) minimum clearance between the
side of the dishwasher door and the wall or cabinet.
HM square opening for proper operation and appearance.
m cabinet front perpendicular to floor.
mg level floor. (If floor at front of opening is not level with floor at
rear of opening, shims may be needed to level dishwasher.)
NOTE: To avoid shifting during dishwasher operation, shims must
be securely attached to the floor.
If dishwasher will be left unused for a period of time or in a
location where it may be subject to freezing, have it winterized by
authorized service personnel.
Make sure pipes, wires and drain hose are within the shaded area
shown in the "Cutout dimensions" section.
Helpful Tip: If the floor in the dishwasher opening is uneven
(example: tile flooring only partway into opening), you will
need to be exact in measuring dimensions and in leveling
dishwasher.