Table of Contents
Advertisement
DESTINATION SETTING METHOD
When the chassis main assy (CHA1) is replaced, the destination
setting is necessary.
Note 1: Remote commander is necessary.
It is necessary to operate by the remote commander, even in case of
models that have not been supplied the remote commander.
(Refer to "ACCESSORIES" on page 28 about the remote com-
mander)
Note 2: It is not necessary for US, Canadian and MARUTI SUZUKI mod-
els to perform the destination setting. Check whether correct des-
tination is set, refer to "Destination setting checking method" on
page 6. If correct destination is not set, perform the destination
setting according to the following procedure.
(When correct destination has been set for MARUTI SUZUKI
model, "MURUTI SUZUKI" screen is displayed on the screen at
startup. (Refer to Note in the "MODEL IDENTIFICATION" on
page 4))
1. Preparing the Destination Setting
Be sure to solder the SL001 on the MAIN board before doing the
destination setting.
– MAIN Board (Conductor Side) –
SL001
2. Destination Setting
Set destination according to the procedure below.
2-1. Setting the Destination Code
1. Turn the power on this unit.
2. Press the [OFF] button on the remote commander.
3. In the state of source off (Home screen is displayed), enter the
destination setting mode by pressing the buttons on the remote
commander in order of the [4] t [5] t [6] (press only the [6]
button for two seconds).
4. The following screen is displayed and the destination setting
mode becomes effective.
(Displayed characters/values in the following fi gure are ex-
ample)
Note: Refer to following "2-2. Entering the Destination Code" for opera-
tion method.
5. The resetting operation is executed by pressing the reset button
after the setting ends, and the unit returns to the normal condi-
tion.
2-2. Entering the Destination Code
Note 1: Input of the destination code cannot be performed by the keys of
Note 2: The model to which the remote commander is not attached can
Note 3: The number buttons on the remote commander cannot be used.
SL001
1. Press the [ V ] or [ v ] button, and select the alphanumeric char-
acter of "0 to F".
2. The digit advances by pressing the [ b ] button.
The digit returns by pressing the [ B ] button.
3. The setting is completed by pressing the [ENTER] button, and
the initialization operation is done.
2-3. Destination Code
AEP and UK models (EUR)
US and Canadian models (UC)
E (NTSC) model (E)
Russian model (RU2)
E (PAL) model (E17)
Indian model (IN)
MARUTI SUZUKI model (IN3)
Saudi Arabia model (EA)
Australian model (ET4)
XAV-W600/W650BT
<DESTINATION SETTING MODE>
0
0 0 0 0 0
E U R : 0 0 0 0 0 0
U C : 0 0 0 0 0 1
E 1 7 : 0 0 0 0 1 2
E : 0 0 0 0 0 3
R U 2 : 0 0 0 0 0 4
I N 3 : 0 0 0 0 1 6
E A : 0 0 0 0 1 A
E T 4 : 0 0 0 0 1 C
main unit. Be sure to input the destination code by remote com-
mander.
also be operated by using the remote commander.
Destination
Destination code
000000
000001
000003
000004
000012
000015
000016
00001A
00001C
– Continued on next page –
5
Advertisement
Table of Contents
