Table of Contents
Advertisement
Problem
comes on the hob display.
comes on the hob display.
comes on the hob display.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation settle
on the food and in the cavity of
the oven.
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Installation
WARNING!
Refer to Safety chapters.
Technical data
Dimensions
Height
Width
www.zanussi.com
Possible cause
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom of the
cookware is too small for the
zone.
The oven is deactivated.
The necessary settings are not
set.
The lamp is defective.
You left the dish in the oven for
too long.
We recommend that you write the data here:
894 - 912 mm
600 mm
Put cookware on the zone.
Use the correct cookware.
Refer to "Hob - Hints and tips"
chapter.
Use cookware with correct di-
mensions.
Refer to "Hob - Hints and tips"
chapter.
Activate the oven.
Make sure that the settings are
correct.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking process
ends.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove
the rating plate from the appliance cavity.
.........................................
.........................................
.........................................
Dimensions
Depth
Location of the appliance
You can install your freestanding appliance with
cabinets on one or two sides and in the corner.
Remedy
600 mm
25
Advertisement
Table of Contents
