Table of Contents
Advertisement
Operation
The machine will move faster the farther the
motion control levers are moved from the neutral
position.
5.
To stop, position both motion control levers in
the neutral operate position.
Driving in Reverse
1.
Move the motion control levers to the neutral
position.
2.
To move rearward in a straight line, slowly move
both front levers rearward with equal pressure.
1. All levers in neutral
position
To turn left or right, release pressure on the
motion control lever toward the desired turn
direction.
3.
To stop, position both motion control levers in
the neutral position.
Adjusting the Cutting Height
The cutting height of the mower deck is adjusted
from 1 1/2 to 5 inches (3.8 cm to 12.7 cm) in 1/4
inch (6.35 mm) increments.
1.
Stop the machine and move the motion control
levers outward to the neutral locked position.
2.
Disengage the PTO.
3.
Push the button down on top of the lever to
disengage the deck lift latch. Pull the handle
Figure 10
2. Front levers in rearward
position
all the way rearward and release the button to
latch the cutting deck into the 5.0 inch (12.7 cm)
transport position.
The deck is raised by pushing the button down on
top of the lever to disengage the deck lift latch.
Then pull the handle rearward and release the
button to place it into the transport lock position.
Note: When changing the cutting height
positions, always come to a complete stop
and disengage the PTO.
g344873
S-Series Model Shown
1. Deck lift handle
4.
Insert the height adjustment pin into the hole
corresponding to the desired cutting height.
See the decal on the side of the deck lift plate for
cut heights.
5.
Slightly pull the deck lift handle rearward and
push the button down on top of the lever to
disengage the transport lock. Slowly release the
handle downward to allow the deck to lower to
the cutting height. Release the button.
Adjusting the Anti-Scalp Rollers
It is recommended to change the anti-scalp roller
position when the height of cut has changed.
28
1
Figure 11
g377365
Advertisement
Table of Contents
