Table of Contents
Advertisement
Note: For X-Series EFI Models Only, the engine
RPM will automatically reduce when the PTO
switch is disengaged to extend the clutch life.
Stopping the Engine
1.
Bring the machine to a full stop.
2.
With the motion control levers in neutral position,
place the throttle midway between the "SLOW"
and "FAST" positions.
3.
Push down on the PTO switch to disengage the
blades.
4.
Engage the parking brake.
5.
Allow the engine to run for a minimum of 15
seconds, then turn the ignition switch to the
"OFF" position to stop the engine.
6.
Remove the key to prevent children or other
unauthorized persons from starting engine.
Driving the Machine
CAUTION
Machine can spin very rapidly by positioning one
lever too much ahead of the other. Operator may
lose control of the machine, which may cause
damage to the machine or injury.
• Use caution when making turns.
• Slow the machine down before making sharp
turns.
Important: To begin movement (forward or
backward), the brake lever must be disengaged
(pushed forward) before the motion control
levers can be moved.
When the motion control levers are positioned in
the center the drive system is in the neutral position
(Figure 5).
Note: The "N" LCD indicator appears when the
levers are in the neutral position, and the brake is
engaged..
With the brake disengaged, the drive system is in the
operate position.
Driving Forward
1.
Step onto the platform of the machine.
Note: The OPC LCD indicator appears when
the operator is on the platform.
2.
Make sure the motion control levers are in the
neutral position.
3.
Release the parking brake.
4.
To move forward in a straight line, move both
rear levers forward with equal pressure.
1. All levers in neutral
position
To turn left or right, pull the motion control lever
back toward neutral in the desired turn direction.
27
Operation
Figure 8
2. Rear levers in forward
position
Figure 9
g344862
g344905
Advertisement
Table of Contents
