GE PGP953 Installation Instructions Manual page 13

Installation Instructions
MAKING THE LP CONVERSION (CONT.)
[3] CHANGE COOKTOP BURNER
ORIFICES
Remove the grates, burner caps, and burner
heads.
Using a 7mm nut driver, remove the burner
orifices. These may be accessed through the
burner holes in the cooktop.
Inner
burner cap
Burner
re, Burner
RZ 8 head
Burner
Outer OR
base
burner
cap
Burner
base
Orifice spud located
through this opening
Electrode
through these openings
Tri-Ring Burner
NOTE: On all burners, the
orifices have a spring-loaded
retaining ring around the hex
head to hold the orifice in the
nut driver during installation
and removal. A slight amount
of force is required to push the
nut driver down over the ring.
Locate the LP orifices attached to the regulator
along with separate LP conversion instructions.
They will have a digit for size and a letter for type
of gas, on the top or side. (IMPORTANT: Save
the orifices removed from the appliance for
Retainer
Ring
future use.)
Each orifice will show a series of engraved
marks, (I, Il, 1V or V), located on the top.
These marks denote the location of each orifice to the
cooktop burner.
For PGP953 Models
©) 7)
x2 WIL x2 mn XL x3
(Shorter)
For PGP959 & CGP350 Models
13
[3] CHANGE COOKTOP BURNER
ORIFICES (CONT.)
CGP350 &
PGP959
Main: 58 L (x3)
Simmer: 51.L
CENTER BURNER
15,000 BTU/hr Extra Large Burner (PGP953 Models)
Burner
Cap
Set Screw
|
>) Choke
|
Extended spud for center
extra large burner
Extended
Spud
Base
6
Orifice spud located
through this opening