Table of Contents
Advertisement
Checking
the recording
- END SEARCH / EDITSEARCH / Rec Review
You can use these buttons
to check the recorded
picture
or shoot so that the transition
between
the last recorded
scene and the next scene you record is smooth.
END
SEARCH
You can go to tire end of the recorded
section after you record.
Press END SEARCH in tire standby
mode.
Tire last 5 seconds
of tire recorded
section are played back and returns
to the standby
mode. You can monitor
the sound from the speaker
or headphones.
You can search for the next recording
start point.
Hold down
the +/-9)
side of EDITSEARCH
in the standby
mode. The recorded
section is played back.
+ : to go forward
: to go backward
Release EDITSEARCH
to stop playback.
If you press START/STOP,
re-recording
begins
from the point you released
EDITSEARCH.
You cannot monitor
the sound.
You can check the section which you have stopped
most recently.
Press the - (@) side of EDITSEARCH
momentarily
in the standby
mode.
The section you have stopped
most recently
will be played
back for a few seconds,
and
then your camcorder
will return
to the standby
mode. You can monitor
the sound from
the speaker
or headphones.
Notes
• END SEARCH,
EDITSEARCH
and Rec Review work only for tapes recorded
in the
DigitalSIE} system.
• If you start recording
after using the end search function,
occasionally,
the transition
between
the last scene you recorded
and the next scene may not be smooth.
• Once you eject the cassette after you have recorded
on the tape, t he end search
function
does not work.
If a tape has a blank portion in the recorded portions
24
The end search function
mav not work correctlv.
Advertisement
Table of Contents
