Table of Contents
Advertisement
Recording
a picture
Noteon LOCK
When you slide LOCK to the left, the POWER switch can no longer be set to MEMORY
accidentally.
The LOCK is released
as a default
setting.
To enable smooth transition
You can make the transition
between
the last scene vou recorded
and the next scene
smooth
as long as you do not eject the cassette if you turn off vour camcorder.
When
you change the battery
pack set tire POWER
switch to OFF (C_HARGE).
If you leave your camcorder in the standby mode for 3 minutes
Your camcorder
autonratically
turns off. This is to save battery
power
and to pwvent
battery
and tape wear. To resunre
the standby
mode, set the POWER switch
to OFF
(CHARGE)
once, then turn it to CAMERA
again.
18
To adjust the brightness
of the LCD screen, press either of the two buttons
on LCD
BRIGHT.
The LCD panel moves about 90 degrees
to the viewfinder
side and about 180 degrees
to
the lens side.
If you turn the LCD panel over so that it faces the other way, the _
indicator
appears
on the LCD screen and in the viewfinder
(Mirror mode).
When closing
the LCD panel, set it vertically
until it clicks, and swing it into the
camcorder
body.
Note
When using the LCD screen except in the mirror mode,
the viewfinder
automatically
turns
off.
When you use the LCDscreen outdoors in directsunlight
The LCD screen mav be difficult
to see. If this happens,
w_, recomnwnd
that you use the,
viewfinder.
Picture in the mirror mode
The picture
on the, LCD is a mirror-image.
How_wer,
the, picture
will be normal
when
recorded.
During recording in the mirror mode
You cannot operate
the ZERO SET MEMORY on the Remote Commander.
Indicatorsin the mirror mode
The STBY indicator
appears
as 110 and REC as O. Some of other indicators
appear
mirror-reversed
and others are not displayed.
Advertisement
Table of Contents
