O Remote Control Unit Preparation - Panasonic CQ-DF402U Operating Instructions Manual

O ura
18
Remote Control Unit Preparation
© Remove the battery holder. (included)
Pull the holder by the position B while pushing posi- Back sida
tion A in the direction indicated by the arrow.
@ Install the battery on the battery holder. En
Set a new battery properly with its (+) side facing up
as shown in the figure.
© Insert the battery holder.
Push in the battery holder back into its original posi-
tion.
Position B
Battery Notes Battery holder Position A
Remove and dispose of an old battery immediately.
Battery Information:
© Battery type: Panasonic lithium battery (CR2025) (included)
o Battery life: Approximately 6 months with normal use (at room temperature)
Caution:
o Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.
Battery leakage may damage the unit.
o Do not disassemble or short the battery. Do not throw a battery into a fire.
o Keep batteries away from children to avoid the risk of accidents.
o Be careful to the local disposal rules when you dispose of batteries.
Control Reference Guide
Buttons of the remote control function in the same way as the controls on the main unit of the reference page.
Point the remote control unit at the main unit's sensor (REMOTE).
Power button (PWR)
(> page 10)
Mode button (MODE)
(=> pages 14, 16)
Mute button (MUTE)
( page 10)
Volume control buttons
(VOL, A V)
(= page 10)
— oy) BAND/DISCIUP)
=
/ co
<< HE,
Band/Disc up* button
(BAND/DISC UP*)
(=> pages 14, 17)
(=> pages 14, 16)
is connected.)