Panasonic CQ-DF402U Operating Instructions Manual page 28

|= Troubleshooting (continued)
Trouble Cause/Step
Disc is Col oie wee. «| down.
=Place Col
oie
wee.
«|
in the correct direction, and the label side up.
© Disc is dirty.
© Disc has scratches.
Disc is in the CD compart- Clean disc, referring to the section on "Notes on CD/CD media (CD-R,
ment but no sound is > CD-RW)".
made, or disc is ejected A disc that has data other than CD-DA type is loaded.
=Discs that have CD-DA type data should be used.
automatically.
© Disc is dirty.
o Disc has scratches.
Clean disc, referring to the section on "Notes on CD/CD media (CD-R,
CD-RW)".
Sound skips, bad sound
quality. (e.g. caused by >
noise) The unit may not successfully play back a CD-R/RW that is made in combi-
nation of writing software, a CD recorder (CD-R/RW drive) and a disc which
are incompatible one another. Refer to instructions for the concerned de-
vices for details.
Mounting angle is over 30°.
> Adjust mounting angle to less than 30°.
Sound skips due to vibra-
tion.
Instable mounting.
Mount the unit securely with the mounting parts, referring to the section on
installation,
o Disc is defective.
o Mechanical trouble.
Disc is not ejected.
The first track of a mix mode disc was reproduced. (Mix mode is a format in
which data except music is recorded on the first track and music data is recorded
on other than the first track in a session.)
Play back music data recorded on other than the first track.
Left and right balance, or front and rear balance is off on one side.
>Adjust balance/fader mode as appropriate.
Cables are not correctly connected,
Connect the cables correctly.
Time is counted but no
sound comes out.
o Sound Setting
No sound from left, right,
front or rear speakers.
| Left and right sounds are
reversed in stereo listen-
ing.
28
| 605D5402/DFX302U |