Table of Contents
Advertisement
Safety Considerations for Installing Switches
Safety Considerations for Installing Switches
Read the information in this chapter thoroughly before you attempt to install or
remove an Extreme Networks switch.
Ensure that proper ESD (electrostatic discharge) controls are in use before switch
maintenance is performed. This includes but is not limited to wrist straps that are
grounded to the switch housing and earth grounds.
Warning
Connect the chassis ground wire before you connect any DC power cables.
Disconnect the ground wire after you disconnect all DC power cables.
Take care to load the equipment rack so that it is not top-heavy. Start installing
equipment at the bottom of the rack and work up.
Do not cover vents that would restrict airflow.
Note
See
information.
What You Will Need for the Installation
Ensure that you have followed the guidance in "Preparing to Install," and ensure that
you have the appropriate people and tools on hand.
Installing Extreme Networks switches is easiest when there are two people to
maneuver the switch and attach mounting hardware.
Provide enough space in front of and behind the switch so that you can service it easily.
Allow a minimum of 122 cm (48 in) in front of the rack and 76 cm (30 in) behind the
rack.
If your switch has internal power supplies, make sure they have the same airflow
direction as the fans in the switch.
Quick Reference Guide for your switch model to see what hardware is provided
Check
in the switch packaging. Most Extreme Networks switches come with the following
hardware:
•
Two rack mounting brackets (ears) adaptable for either a front-mount or mid-mount
installation.
•
Two long mounting brackets (rails) or slider kits for mounting in a four-post
installation.
•
Screws for attaching mounting hardware to the switch housing.
74
ExtremeSwitching 5420 Series Hardware Installation Guide
Safety and Regulatory Information
Installing Your Switch
on page 113 for additional safety
Advertisement
Table of Contents
