About The Newline Function; Displaying The Jump Command Menu - Casio CFX-9800G Owner's Manual

Other Useful Cursor Movement Functions
The following functions also come in handy when moving the cursor around inside a file.
FA(TOP) ... Moves the cursor to the top of the data.
Example
Fi\(TOP)
:
Ars SxAeL
T2+12xA°3
TOP ETM Rn
ta}
F2)(BTM) ..-.sssseseeee Moves the cursor to the end of the data.
Example
=
:
PA TOxXAL a
(F2)(BTM
)
[2Ei SA Sa
|
Tor [eT Meio?
iz)
12-7 Program Commands
Fy) 62) 3] (Fa) (Fe)
(Q(JMP) . Displays jump_command 'menu . s i
F2](REL) .
Displays relational operator. menu
:
F3)(Prg)
inputs "Prog" for program.area specification
F4)(?)
FS (4).
Prompt command for value input
.. Display result command
Multistatement connector
—302-—
©The input in response to a prompt:command ''?" can be.a'value or calculation expres-
sion up-to 111 bytes long..No non-calculation command: or multistatement can be per-
formed while the calculator is waiting for input in response to a prompt command.
*The display result command:"' 4" causes program execution to stop while the calcula-
tion result up to the display result command or a-text message is displayed. To resume
program execution, press 2). The final result of the program execution is displayed regard-
jess of whether or not this command is included 'at the end. Note, however, that this
command should be used at the end of the BASE Mode program in order to return the
unit to its original mode following the program.
*The multistatement connector "':" is used to connect two or more statements together
for sequential execution. Unlike statements connected by the display result command,
statements connected by the multistatement connector are executed from beginning to
end, non-stop. Note that you can also use the Newline Function (described below) to
connect statements, and make them easier to read on the display.
WAbout'the Newline Function': is anu
The Newline Function is a multistatement connector that; performs a newline operation
instead of inserting a "':" symbol at the connection of two statements.
Note the two following displays.
Press Ga) here.
Both displays show the same programs, except that the upper one uses multistatements
commands, while the lower one uses the: Newline Function. Note how much easier the
lower display is to read. -
To use the. Newline Function :
To-perform a newline operation at the end of a-statement, press.
Displaying the Jump Command Menu
cr ea ENIMP)
te