Cable Assembly (Power Inlet To Base Hub) - Bowflex IC Bike SE Service Manual

11. Record the number of threads showing on the
Tensioner Eyebolt on each side of the Spindle Clip.
12. To loosen the Flywheel hardware, use a 19 mm open
end wrench to hold the Flywheel Axle Nut on one
side steady and loosen the Flywheel Axle Nut on
the opposite side with a 19 mm socket and wrench.
Remove the Flywheel Axle Nuts from the Flywheel
axle. Set the hardware safely aside for reassembly.
13. Using a 13 mm wrench, loosen the Tensioning Bolt.
14. Using a 10 mm wrench, loosen and remove the
Flywheel Retainer Nut from the Tensioner Eyebolt.
Remove the Tensioner Eyebolt (and Spindle Clip)
from the Flywheel axle. Set the Tensioner hardware
aside.
NOTICE: It may be necessary to move the Flywheel. This
step may require two people.
15. Remove the ziptie that attaches the Speed Sensor
cable to the Flywheel Bracket. Disconnect the
Speed Sensor cable from the Cable Assembly.
16. Carefully turn the Drive Pulley and ease the Drive
Belt off the Drive Pulley to the outside.
Be sure to keep fingers clear of all pinch
hazards as you turn the Drive Pulley and
Flywheel.
Left side - Tensioner assembly
Axle nut Axle nut
Left side
62
Spindle Spindle
clip clip
Tensioner Tensioner
eyebolt eyebolt
Retainer Retainer
nut nut
Cable Cable
assembly assembly
Flywheel Flywheel
bracket bracket
Ziptie Ziptie
Speed Speed
sensor sensor
cable cable