Advertisement
Things To Know Before You Start
socotone
i)
The correct Senin level i is automatically set ee the ALC
(Automatic Level Control) function, and is not affected by the
VOLUME control on the Unit or by the use of sound effects.
--Two small tabs on the back of the cassette tape, one for side A
and one for side B, can be removed to prevent accidental erasure
or recording.
: To record on a cassette with the tabs removed, you must cover:
the holes with adhesive tape as shown.
Notes:
Use normal tapes (not metal or CrO2 tapes) for recording.
At the start and end of cassette tapes, there is leader. tape which
cannot be recorded onto.
If a recorded tape you make has excessive noise or static, the
Unit may have been too close to a TV during the recording.
Either turn off the TV or increase the distance between the TV
and the Unit
= Tune in to a radio station.
Press the © REC button on the Unit.
~The PLAY button is pressed at the same time, the "REC" indi-
cator lights up, and the Unit begins recording.
*
The tape is recorded and then stops when:it reaches the end.
RC-QN1/QN2/QN3
i
(Recording)
REC indicator
To pause the recording, press the PAUSE button on the Unit.
To cancel pause, press the PAUSE button again. Recording con-
tinues from the point where it was paused.
To stop recording, press the @/& STOP/EJECT button.
To remove the tape, stop the tape, and press the m/& STOP/
EJECT button again to open the cassette holder.
When chine an AM broadcast, beats may be ianieed which
are not heard when listening to the broadcast. If this happens, you
can use the BEAT CUT function.
Switch the pinapiai CUT ewer
On
OF a4 to 2 or 3.
Note: In regular use, the BEAT CUT switch
should be set to the NORM-1 position.
The CD Player can be started with the:Cassette Deck for synchro-
nous recording and everything on the CD recorded onto the tape in
the order
it is on the CD.
| Insert a cassette tape in the Cassette
ck and wind peat t the leader tape..
ada CD...
Press the g button to stop the CD.
«
You can check the number of tracks and the total playback time
of the CD on the display. (See page 6.)
Select the Repeat mode of the CD if
desired.
To select the Repeat mode
(C~ or C~ ALL), press the RE-
PEAT button on the Remote Control.
noose whether to have approx. four sec-
.
twee }
ks...
'if you. want the blank Se tion, Fins this step...
if you do not want the blank section, perform the follow-
ing operation on the CD Player.
¢«
Press the CD »/it button twice.
, Press the.e REC button on the Unit.
The PLAY button is pressed at the same time, the "REC" indi-
cator lights up, and the synchronous recording begins.
¢
The tape is recorded and then stops when it reaches
the end..
¢
Tocontinue recording to the other side of the tape, perform the
following steps.
1-13
Advertisement
