Advertisement
RC-QN1/QN2/QN3
page
8.)
Note: If "howling" occurs, keep the microphone away from the
Unit.
gintoa radio 'station. (S$
Connect a microphone by plug
the MIC jack on the back of ti
Adjust the volume level, as you sing into
the microphone.
Handle your CDs carefully, and d they w will last a. along th time.
Compact Discs»
¢
Only CDs bearing this mark can be used with
this Unit.
If a tape 1s loose, it may get stretched,
cut, or
caught in the cassette. Take up the slack by
inserting a pencil in one of the reels and rotat-
ing in the right direction.
Continued use of irregularly shaped CDs
(heart-shape, octagonal, etc.) can damage the
Unit.
Do not touch the tape surface.
*
Remove the CD from its case by holding it at
the edges while pressing the case's center hole
lightly.
¢
Do not touch the shiny surface of the CD, or
bend the CD.
Do not store the.tape:
-
In dusty places
-
In direct-sunlight or heat
-
In damp. areas
-
OnaTV or-speaker
¢
Put the
CD back in its case after use to prevent
-
Neara a magnet
warping.
sormscrenonnenes mentee
~—e
en
.
Be careful not to scratch the surface of the CD
Cassette
[ oe eck
when placing it back in the case.
e
Ifthe heads, capstan, or pinch-roller in the Cassette Deck
*
Avoid exposure to direct sunlight, temperature
become dirty, you may experience:
extremes, and moisture.
-
Loss of sound quality
-
Discontinuous sound
-
Fading .
-
Incomplete erasure
-
Difficulty: recording _
¢
Clean the heads, capstans, and pinch-rollers using a cotton
swab moistened with alcohol.
¢
A dirty CD may not play correctly. If a CD is
dirty, wipe it with a soft:cloth in a straight line
from center to edge.
CAUTION: Do not use any solvent (for oxamptc,
conventional record cleaner, spray thinner,
ben-
zine, etc.) to clean a CD.
Moisture Condensation
Moisture may condense on the lens inside the
Unit in the following cases:
Capstan ——"—
¢
After turning on heating in the room.
Record/Play head
¢
Inadamp room.
¢
Ifthe Unit is brought directly from a cold to
e
Ifthe heads become magnetized,
the Unit will produce noise. or
awarm
place.
lose high frequency notes.
Should this occur; the Unit may malfunction. If
¢
To demagnetize the heads, turn off the Unit, and use a head
this: tiappens, leave it turned on for a fewhours:
demagnetizer (available at electronics and record shops).
until the moisture evaporates; unplug the AC
power cord, and then plug it in again.
Pinch roller
Erase head
General
es
To ensure top performance, keep your CDs and the mechanism clean.
¢
Store CDs in their cases, and keep them in cabinets or on
shelves.
¢«
Keep the CD holder-ciosed when not in use.
12
1-26
Advertisement
