Advertisement
• Take care not to soil or scratch the mirror surface
(opposite to the printed surface). Do not write
anything or put a sticker on either the front or back
surface, if the CD-ROM gets dirty, gently wipe it with a
soft cloth outward from the center hole using a circular
motion.
• Do not use conventional disc cleansers or cleaning
spray.
• Do not betld the CD-ROM or touch its mirror surface.
• Do not store your CD-ROM in a dusty, hot or humid
environmettt. Keep it away from direct su_ftight.
About
moisture
condensation
•..
• You have observed that pouring a cold liquid into a
glass will cause drops of water to form on the glass
outer surface. This same phenomenon
occurs on the
head drum of a camcorder
when it is moved from a
cool place to a warm place, after heating a cold room,
under extremely
humid conditions or in a place
directly subjected to the cool air from an air
conditione_
• Moisture on the head drum can cause severe
damage to the video tape, and can lead to internal
damage to the camcorder
itself.
Serious malfunctioning
If malfu_ctioning occurs, stop using the unit
immediately and consult your local JVC dealer.
The camcorder is a microcompoter-centrolled
device. External noise and interference (from a TV,
a radio, etc.) might prevent it from functioning
properly, fn such cases, first disconnect its power
supply unit (battery pack, AC Adapter, etc.) and wait
a few minutes and then re-concect it and proceed
as usual from the beginning.
1) After Use
t, Turn off the camcerder.
2. Slide and hold OPEN/EJECT _) in the direction
of the arrow, then pull the cassette holder cover
open u_ltil it locks. The cassette holder opens
automatically. Remove the cassette.
3. Press "PUSH HERE" to close the cassette holder.
• Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette holder cover.
4. Tilt the viewfinder upward. Press BART.
RELEASE _ and remove the battery pack.
2) Cleaning The Camcorder
1. TOclean the exterior, wipe gently with a soft cloth.
Put the cloth in diluted mild soap and wri_lg it well
to wipe off heavy dirt. Then wipe again with a dry
cloth.
2. Open the LCD monitor. Wipe gently with a soft
cloth. Be careful not to damage the monitor.
Close the LCD monitor.
3. TOclean the lens, blow it with a blower brush,
then wipe gently with lens cleaning paper.
NOTES:
• Avoid using strong clean_ng agents such as benzine or
alcohol.
• C;eaning should be done only after the battery pack has
been removed or other power units have been
disconnected.
• MoId may form if the lens is left dirty.
• When using a cteaner or chemically treated cloth refer to
the cautions of each product.
EN
CAUTIONS
43
Advertisement
