Table of Contents
Advertisement
Operation
To turn the ViewSonic VP151 ViewPanel
ViewPanel ON (see page 7), THEN turn on your computer. The power light on the VP151
will then turn green indicating the ViewPanel is ready to use. To turn the ViewPanel off, set
the power switch OFF. The power light will turn red. To completely power down the
ViewPanel, turn off the power switch on the DC Power supply.
To start, follow the instructions for Landscape/Portrait Mode, or begin using the control
E
buttons shown below and on page 11.
N
Landscape / Portrait Modes*
G
L
The VP151 ViewPanel can operate in either Landscape or Portrait mode (see below).
I
S
H
Landscape
To switch from Landscape (default) to Portrait modes, do the following: (1) Face front of
ViewPanel. (2) Pull bottom of ViewPanel toward you to tilt bottom away from base.
(3) After tilting ViewPanel, manually rotate the VP151 clockwise 90°.
To switch from Portrait to Landscape mode, follow steps 1 - 3 above, but manually
rotate the VP151 panel counter-clockwise 90°.
INPUT button
toggles between
two digital inputs
*PerfectPortrait software is compatible with most PCI and AGP graphics (video) cards. For
information on compatible graphics cards and approved hardware configurations, go to the
ViewSonic website, http://www.viewsonic.com, and select the following path: Customer
support > Support options > Document area > PPCHART.XLS. The PPCHART.XLS
spreadsheet will provide information on compatibility with your graphics card.
10
Operation
®
on, press the power switch on the front of the
Portrait
Increases
Decreases
brightness
brightness
NOTE: Before using the
portrait display mode,
you must first install the
TM
PerfectPortrait
* software
included with your
VP151 ViewPanel. Follow
the instructions that
accompany the
PerfectPortrait software.
Power on/off
Base Control buttons
(See page 11 for
description of use).
ViewSonic VP151 ViewPanel
®
Advertisement
Table of Contents
