Aiwa Z-L520 Operating Instructions Manual page 8

MONO
TUNER
BAND
SHIFT
<< >>
7 Press TUNER/BAND to select the FM or AM band.
When TUNER/BAND is pressed while the power is off, the
power is turned on directly (Direct Play Function).
To select a band with the remote control
Press BAND while pressing SHIFT.
2 Press TUNER PRESET repeatedly to select the
manual tuning mode.
Each time the button is pressed, the following three tuning
modes are selected cyclically.
@ Preset tuning mode: The preset number flashes.
@ Auto search mode: "SEARCH' is displayed.
@ Manual tuning mode: "SEARCH?" is not displayed and
the preset number does not flash.
Frequency Preset number
SEARCH
The preset tuning mode is skipped if no station is preset.
3 Turn MULTI JOG clockwise or counter-clockwise
to tune in to a station.
The frequency changes as you turn MULTI JOG. When a
station is received, "TUNE" is displayed for 2 seconds.
During FM stereo reception, {t@))) is displayed.
¢ <<4DOWN and »P UP are also available to tune in to a
station.
8 ENGLISH
To search for a station quickly (Auto Search)
Press TUNER PRESET repeatedly to display "SEARCH" (auto
search mode), and turn MULTI JOG clockwise or counter-
clockwise until the frequency starts to change rapidly. After tuning
in to a station, the search stops.
SEARCH
To stop the Auto Search manually, turn MULTI JOG a little in
either direction.
¢The Auto Search may not stop at stations with very weak
signals.
¢ << DOWN and PF UP are also available to search for a
station. Keep <<4DOWN or UP pressed until the tuner
starts searching. Press the button to stop the search manually.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control while pressing SHIFT
so that "MONO" appears on the display.
Noise is reduced, although reception is monaural.
MONO
me
To restore stereo reception, press MONO TUNER on the remote
control while pressing SHIFT so that "MONO" disappears and
"STEREO? is displayed for 2 seconds.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. if
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNER/BAND on the unit.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.